Types of connection to the heating system
All radiators are supplied as standard with 4 connections, each 1/2". Connections with 3/4" are also available on request at no extra cost.
This means that the connection types SIMULTANEOUS and ALTERNATIVE to any heating system are possible.
In addition, we offer the connections from and to the TOP with a built-in baffle plate on the return side, so that there are no losses in heating capacity, as well as the connection type from and to BOTTOM, with a built-in baffle plate on the flow side.
Standard:
Connection on the same side left or right
Standard:
Connection alternately left or right
Special connection: from and to the top
In this case, an additional blanking plate is installed on the return side before the last element (above) to prevent power losses (without a blanking plate, most of the hot water would flow through the top and not heat up the radiator properly).
Special connection: from and to the bottom
In this case, a dummy disk is also installed on the flow side after the first element (below) to prevent power losses (the hot water would partly run through the top without a dummy disk and not heat up the radiator properly)
