Electric execution for cast iron radiators

All of our cast iron radiators are also available in electric executions. The equipment with an electrical heating cartridge allows the connection of the radiator to a socket (or hard wiring). This means that the radiator can be operated independently of a conventional heating system.

The heating rods used are installed in the lower hub of the radiator. The cast iron radiator is filled at the factory and functionally tested.

Our cast iron radiators are available from 500 watts to 1500 watts. From simple control to Bluetooth and WLAN control and integration into bus systems.

Heating element NEX

• Bluetooth operation via an application for a mobile device
• daily and weekly work schedule of the device energy consumption meter
• room temperature measurement / heating function interruption for the time when the window/door is open
• TURBO timer – the heating element maintains the set temperature for the set time up to 4 hours. After that, the heater will return to the previously set temperature
• START-STOP timer – The heater will keep the set temperature for the set time up to 4 hours. After that, the heater will turn off
• DELAYED START timer – The heater will turn on with a delay (from 1 to 8 hours). It starts to heat up to the set temperature and maintains it for a set time of up to 4 hours. After that, the heating element turns off
• 4-level temperature control in the range of 30–60°C
• the ability to turn the regulator in the range of 0-330°C
• ANTIFREEZE function
• 2-level overheating protection
• additional protection against “dry” operation
• low power consumption in standby mode (Ultra - Low power
• dryer function

Electric heating element NORD

with simple operation and intelligent heat control:

• START-STOP timer - automatic switch-off after a programmed time
• 3-stage temperature control: ECO - 30C, 45C, 60C
• dryer function
• 2-stage overheating protection
• additional protection against "dry" operation
• ANTIFREEZE function

Heating element SIMPLE

Simple heating element for on-site controls (e.g. switched sockets, control via room thermostat or integration into bus systems).